|
Use
Promotional Code
CED300314
and save 30%
on any course with CEDengineering.com
Purchase your courses by 3/16/14 and come back to take the quiz any time afterwards.
|
Become a Course Provider and earn 50% Royalties
Louisiana & Texas Engineers!
Your license renewal deadline of March 31st is coming up.
New Jersey Engineers!
Your license renewal deadline of April 30th is coming up.
Earn all your PDH's online with CEDengineering.com including:
Ethics Courses for LA, NJ & TX Engineers
New Jersey Ethics
CEDengineering.com
is an approved provider by the:
LA Board
(No. 0000244)
NJ Board
(No. 24GP000004100)
|
Need to check your state board requirements?
View All Categories
|
|
Dear [fname] [lname]
Enjoy a 30% savings on all CEDengineering.com courses including our latest online PDH course releases. Use Promo Code CED300314.
Impact of Animals on Earthen Dams, 8 PDH
Course No. C08-016
|
|
This course will introduce you to the principles and practices of identifying problems in existing earthen dams that are the result of animal activity. This course will also give you an introduction to the steps necessary to protect a dam from potentially serious damage from nuisance wildlife.
|
*****
SCADA System Fundamentals, 1 PDH
Course No. E01-007
|
|
SCADA systems are found wherever processes are being run with large amounts of data to be monitored. This course provides the basics of Supervisory Control and Data Acquisition (SCADA) Systems as well as an understanding of the basic terminology and components of a SCADA system.
|
*****
Elec. Eng. Fundamentals: Motors, Generators, Power Dist., 8 PDH
Course No. E08-003
|
|
This course introduces the concept of load factor, its role in power quality considerations and electrical energy cost reduction through peak shaving. Significance of electrical equipment service factor and voltage regulation of power distribution systems is also highlighted.
|
*****
Eng. Ethics Case Study: The Taum Sauk Reservoir Failure, 5 PDH
Course No. LE5-001
|
|
This course provides instruction in engineering ethics through a case study of the Taum Sauk failure. It also discusses the interaction between decisions made in the original design process in the 1960s and errors made in the installation of new water-level control instrumentation in 2004.
|
*****
Air Spring Applications: Actuators & Vibration Isolation, 3 PDH
Course No. M03-029
|
|
This course provides guidance on the selection, application and design of equipment using air springs. It explains the application advantages of air springs versus air or hydraulic cylinders. It also explains why air springs can be better than coil springs in vibration isolation applications.
|
*****
Continuous Emission Monitoring Guide, 8 PDH
Course No. C08-015
|
|
This course presents the Continuous Emission Monitoring Rule (40 CFR Part 75) which establishes the continuous emission monitoring standards for air pollution, and reports requirements under EPA’s Acid Rain Program which was instituted in 1990 under Title IV of the Clean Air Act.
|
*****
Shot Peening Technology, 2 PDH
Course No. T02-008
|
|
Shot peening is a metal working operation that is used to enhance the fatigue life of a great variety of manufactured engineering components and assemblies. This course describes the operations of various types of shot peening devices as well as the advantages and disadvantages of each.
|
|
